Adding a gas fireplace to a room with no chimney.
A direct-vent gas fireplace does not need a chimney. It needs a path to the outside, through a wall or up through the roof, and a spot on the outside of the house where the vent cap is allowed to sit. Here is how that works, and the rules that pick the spot.
Most of the gas fireplaces we install go into rooms that never had a chimney. A den, a bedroom, a finished basement, an addition. People ask whether that is even possible. It is. What decides the job is where the vent comes out.
This post is about vented units. A vent-free fireplace needs no vent at all, and our post on vented or vent-free gas logs covers the room-size rules for those. If the room already has a chimney, see three ways to fix a fireplace that does not heat for inserts, stoves and new fireboxes.
How a direct-vent fireplace works
A direct-vent fireplace is sealed from the room. The glass front is closed, and the fire never touches the air you breathe indoors. The residential code defines it that way: all of the air for burning comes straight from outside, and all of the exhaust goes straight back out.
The vent does both jobs at once. It is a pipe inside a pipe. On the White Mountain Hearth fireplaces we use as examples here, that is a 4 inch pipe inside a 6 5/8 inch pipe. One carries exhaust out. The space around it brings fresh air in. Both end at one cap on the outside of the house.
Out the wall or up through the roof
There are two ways out. A horizontal run goes through an outside wall and ends in a cap on the side of the house. A vertical run goes up through the ceiling and the roof and ends in a cap above the shingles.
A fireplace on an outside wall usually vents through that wall. It is the shortest path. A fireplace on an inside wall, or on an outside wall that cannot take a cap, usually goes up.
Top vent or rear vent
Where the pipe leaves the fireplace matters too. Some models vent only from the top. Others can vent from the top or straight out the back.
- Top vent. Empire's manual for the Tahoe Premium (DVCP32, 36 and 42) has the pipe leave the top of the firebox and rise at least 12 inches before the first elbow. From there it turns toward the wall or keeps climbing to the roof.
- Rear vent. Empire's manual for the Tahoe Deluxe (DVD32 to DVD48) allows either. Running straight out the back with no elbow, the pipe can be up to 24 inches long on the 32, 36 and 42 inch models, and 6 inches on the 48. That suits a fireplace set right against the outside wall. The same manual warns that some fireplaces cannot be vented out the rear at all.
How far the pipe can run
Each manual has a graph that pairs how high the pipe rises with how far it can run sideways. For the Tahoe Premium:
- Up to 40 feet of vertical run, and up to 20 feet of horizontal run.
- To use the full 20 feet sideways with one elbow, the pipe has to rise at least 8 feet first.
- Every 90 degree elbow in the horizontal run takes 3 feet off the limit. Every 45 degree elbow takes 18 inches. A wall installation can use two 45 degree elbows at most.
- Through the roof, the cap has to clear the roof by a height set by the pitch: 12 inches on a roof up to 6/12, 24 inches on a roof steeper than 8/12 and up to 16/12. The pipe keeps 2 inches from anything combustible as it passes through.
This is why the spot in the room and the spot on the outside wall have to be chosen together. A fireplace across the room from the only good wall may not reach it.
Where the vent cap is allowed to sit
Georgia's gas code is the 2024 International Fuel Gas Code with Georgia amendments, in force since January 1, 2026. Houses fall under the residential code, whose gas chapter repeats the fuel gas code's venting section as G2427. Table 503.8 sets minimum distances for a cap on a wall. For corners, soffits and fixed windows it defers to the manufacturer, so the manual fills those in.
Here are the U.S. numbers from the Tahoe Premium manual, figure 22. The code agrees wherever it sets a number.
- Above the ground, a deck or a porch. At least 12 inches.
- A window or door that opens. This depends on the fireplace's heat output. It is 9 inches for a unit between 10,000 and 50,000 Btu per hour, and 12 inches above that. The Tahoe Premium's maximum runs from 22,000 to 28,500 depending on size and gas, so 9 inches.
- A window that does not open. 12 inches. The code leaves this one to the manufacturer.
- A soffit above the cap. 24 inches below a vented soffit within 2 feet to either side. 12 inches below a solid one.
- Corners. 6 inches from an outside corner, 9 inches from an inside corner.
- The gas meter. Not within 3 feet to either side of the meter and its regulator, anywhere above them. 6 feet from the regulator's own vent opening.
- A fan-driven air intake. 3 feet above it if the cap is within 10 feet of it sideways.
- Under a porch, deck or balcony. Allowed only if the space underneath is open on at least two sides, and then 12 inches below the floor.
- Over a public sidewalk or paved drive. 7 feet up. Never over a sidewalk or driveway that runs between two houses and serves both.
The manual adds three more when it describes cutting the hole. The bottom of the hole sits at least 12 inches above the ground. The top of the cap sits at least 18 inches below an overhang made of anything that burns. And it stays 9 inches from a wall running alongside it.
Those clearances assume wood or metal. Vinyl is not included. Empire will not cover heat damage under a vinyl soffit or overhang.
Other models have their own numbers. The manual for the unit you buy is the one that counts.
What rules a wall out
Any of these sends us looking for another wall:
- The gas meter is on it, near where the cap would land.
- A low eave or a vinyl soffit sits right above.
- Windows that open sit close on both sides of the spot.
- The wall is under a covered porch or deck that is open on one side only.
- It faces a narrow side yard path or a driveway shared with the house next door.
- The ground is too high, as on a basement wall. Empire recommends a snorkel kit there, which lets the pipe pass through the wall as low as 7 inches below grade, measured to its center. It also recommends a window well with proper drainage around the cap.
- The wall is too far from where the fireplace has to sit.
The cap also cannot be recessed into a wall or tucked behind siding. It has to sit on the face of the house in open air.
Rome's historic districts and HOAs
Rome has five local historic districts. Exterior work in them is reviewed under the Historic Preservation Commission's rules before a building permit is issued. The city's district guidelines call for ventilators and mechanical equipment on side and rear walls that are not visible from public view. They do not allow them on roof slopes visible from the street.
The guidelines do not mention fireplace vent caps by name. But if your house is in one of those districts and the only good wall faces the street, talk to Rome-Floyd Planning first, at 706-236-5025.
Outside those districts, a neighborhood HOA may have its own rules for anything on the outside of the house. Check before the hole is cut.
Permits
A gas fireplace means gas piping and a vented appliance. Treat it as permitted work. Rome's building inspection office describes its mechanical permit as covering new heating and venting equipment. Cherokee County's permit application notes that heating work may need a separate permit. Ask your building department which applies, and keep the paperwork.
What to send us
- Photos of the outside wall where you would like the fireplace. Show the windows, doors, gas meter, the eave above and the ground below.
- The distance from where the fireplace would sit to that wall, and what is above the room: an attic, or another floor.
- Natural gas or propane.
- Whether the house is in a Rome historic district or under an HOA.
The fireplaces themselves are on our White Mountain Hearth and fireplaces pages. Once you have a spot, our post on hearth size and mantel clearance covers how close a mantel can sit.
Sources
- Georgia Department of Community Affairs, memo of December 1, 2025, for the adoption of the 2024 International Residential Code and the 2024 International Fuel Gas Code, each with Georgia amendments, effective January 1, 2026
- Georgia State Amendments to the International Fuel Gas Code (2024 Edition), revised January 1, 2026, section 300.1, which sends one- and two-family houses to the residential code; the amendments do not change section 503.8
- Georgia Fuel Gas Code 2024, chapter 5, as published by UpCodes, section 503.8 and Table 503.8, for through-the-wall direct-vent terminal clearances
- Georgia Residential Code 2024, chapter 24, as published by UpCodes, section G2403 for the definition of a direct-vent appliance and section G2427 (503) for venting
- Empire Comfort Systems, Tahoe Premium DVCP(32,36,42)BP installation instructions, 43130-2-0925, page 7 for outside combustion air and exhaust, page 8 for heat input, pages 15 and 16 for termination clearances and the vinyl disclaimer, pages 28 to 32 for the 4 by 6 5/8 inch vent, the 12 inch rise, run limits, elbows, the snorkel kit and the wall opening, and pages 35 and 36 for roof heights, roof clearance and caps that may not be recessed
- Empire Comfort Systems, Tahoe Deluxe DVD(32,36,42,48)FP installation instructions, 43115-3-1024, page 8 for top or rear venting and page 23 for the maximum straight rear run
- Empire, Tahoe manuals page, where both manuals are listed
- City of Rome, Historic Preservation Commission, for the five local historic districts, review of exterior work before a building permit, the district map and planning staff at 706-236-5025
- Rome Historic District Guidelines, 2020, guideline 2.2 on roof features and mechanical equipment visible from the public right-of-way and guideline 16.2 on ventilators and mechanical equipment on secondary and rear facades
- City of Rome, Building Inspection frequently asked questions, for the mechanical permit description
- Cherokee County Building Development Services, residential permit application, for the separate permit that may be required for heating work
The clearances here are Empire's for the models named. Other fireplaces have their own, in their own manuals. Nothing here replaces that manual or your local building department.
No chimney in the room?
Send us a photo of the outside wall.
We will tell you whether the vent can go there, or where it can go instead. We call back within one business day.